1) can be done immediately, 2) depends on some #1 task or ranks lower than other #1 tasks
1) Andrew: Reattach the lose wire from the sensor
2) Andrew: Get a threshhold code ready, which uses both sensors in Flossy
3) Andrew: Look at Calibration Data from today and make a decision about size of moving average (1,3,5...) and shift (or shift function).
1) Ethan: Get the red dye out of Flossy, rinse with tap water
2) Ethan: Figure out how to secure Arduino, extra outlet, etc. Where it can reach Flossy and won't get wet or fall
2) Ethan: Fill about a quarter full with water, then SLOWLY scoop sand into Flossy's sand compartment.
3) Ethan: Secure sensors to holders
4) Set-up Over flow funnel
1) Sheiny: We need the buckets your solution is in for Flossy, probably tomorrow. Get solutions into other buckets. Reattach the pieces you took off those buckets, hopefully you remember how they were attached before.
2) Sheiny: Help Ethan or Andrew if either needs help with anything.
3) Sheiny: Work on the salt water metal/silicone/sand measurements.
SOMEONE: get ready to talk at Lunch, not Andrew's turn this week.
EVERYONE: trip to menards, probably, unless I get enough of the items on my way in tomorrow... We need buckets and a C clamp before much can happen...
I'm really excited, hoping we can see some fluctuating flow tomorrow.... (which might mean we could try a real dye experiment Friday (except stuff will probably go wrong).
No comments:
Post a Comment